Click Buttons and Links with the Keyboard on Mac
Click a button or link on your Mac by typing its hint in Cursor Crane. Element Mode identifies targets so you can choose the control you want without steering the mouse to it.
- In Command Mode, run
command.moveCursorToElementAndLeftClickusing its configured sequence, or invoke its assigned shortcut. - Type the complete hint on the button or link.
- Cursor Crane clicks when you press the final hint key. Depending on the target, it either moves the pointer and clicks or runs an Accessibility action in place.
Enter clicks at the current pointer position. To choose a labeled target, finish typing its hint.
Set the click count
Section titled “Set the click count”After opening Element Mode, Grid Mode, or Find Mode with a click command, press Option + 0–9 before confirming the target. You can use the number row or the numeric keypad. Each digit replaces the current count, including any numeric prefix entered in Command Mode. The count carries over if you switch between Element Mode and Grid Mode.
| Count | What happens when you confirm |
|---|---|
0 | The status shows Move only. The pointer moves for targets that use mouse clicks. For targets that use an Accessibility action, the pointer stays in place and Cursor Crane skips the action. |
1 | The command uses its default behavior, just as when you omit the count. The status has no count suffix. |
2 or higher | The status shows the count, such as ×2. Cursor Crane sends that many mouse clicks, even for targets that normally use an Accessibility action. |
For example, press Option + 2 after starting the left-click command, then type the target’s hint to double-click. The count shortcut applies to click commands. Move-only and drag commands keep their usual controls.
Repeat or hold a click
Section titled “Repeat or hold a click”Open Element Mode, Grid Mode, or Find Mode with a single-click command. For example, if the target hint in Grid Mode is JK, type JK and keep holding K to keep the mouse button down. Release K, then press it again within the repeat-click interval to click a second time.
In Find Mode, hold Shift while typing the initial hint. You can release it before pressing the last hint key again.
Subsequent mouse clicks happen at the current pointer position. For an Accessibility action, each press of the last hint key runs the action again. The hold gesture applies to mouse buttons. Confirming with Enter or through directional navigation, or running a fixed click sequence such as the dedicated double-click command, completes the action without holding or repeating it.
Under Settings > General > Hint Confirmation, Enable repeated clicks is on by default. The Repeat-click interval (ms) defaults to 250 ms and can be set from 100 to 500 ms. When repeat clicks are off, you can still hold a mouse click until you release the final hint key.
Press a different key to end repeat clicking. That key is handled after you leave the selection mode. Esc is reserved for exiting the mode.
What to check
Section titled “What to check”Choose the command that includes a left click, rather than the move-only command. If a target has no useful Accessibility hint, try switching to OCR with Tab, or use Grid Mode to position the pointer geometrically.